Mariner 2WD V6-3.0L VIN 1 (2006)
Accumulator HVAC: Service and Repair
SUCTION ACCUMULATOR
Removal and Installation
NOTE:
-
Hybrid shown, all others similar.
-
Installation of a new suction accumulator is not required when repairing the air conditioning system, except when there is physical evidence of
contamination from a failed A/C compressor or damage to the suction accumulator.
1. Recover the refrigerant.
2. Disconnect the A/C cycling switch electrical connector.
3. Disconnect the suction accumulator inlet and outlet fittings.
-
Discard the O-ring seals.
4. Remove the 2 suction accumulator bracket nuts.
-
To install, tighten to 8 Nm (71 lb-in).
5. To install, reverse the removal procedure.
-
Install new O-ring seals.
-
Lubricate the refrigerant system with the correct amount of PAG oil.
-
For Hybrid vehicles, install the suction accumulator upside down, then rotate into position.
6. Evacuate, leak test and charge the refrigerant system.
