Mariner 2WD V6-3.0L VIN 1 (2006)
Auxiliary Water Pump: Service and Repair
AUXILIARY COOLANT FLOW PUMP
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Drain the engine coolant.
3. Remove the lower splash shield.
4. Release the 2 clamps and disconnect the 2 auxiliary coolant flow pump heater hoses.
5. Disconnect the auxiliary coolant flow pump electrical connector.
6. Remove the 2 bolts and the auxiliary coolant flow pump.
-
To install, tighten to 7 Nm (62 lb-in).
7. NOTE: Lubricate the coolant hoses with water if needed.
To install, reverse the removal procedure.
-
Fill the engine cooling system.
