Mariner 2WD V6-3.0L VIN 1 (2006)
Brake Bleeding: Service and Repair
Brake Fluid Replacement
Brake Fluid Replacement
WARNING: Use of any other than the approved DOT 3 brake fluid will cause permanent damage to brake components and will render the
brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If
brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink
water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash the
surface with water.
CAUTION: Do not allow the brake master cylinder reservoir to run dry during the bleeding operation. Keep the master cylinder reservoir filled with
the specified brake fluid. Never reuse the brake fluid that has been drained from the hydraulic system.
CAUTION: Do not allow the master cylinder brake fluid to overflow from the reservoir. Brake fluid may damage the high-voltage components.
NOTE: Bleeding the HCU is required only when removing or installing the HCU, master cylinder, or opening the lines to the HCU.
NOTE: Make sure that the brake fluid level is above the MIN mark.
1. NOTE: Adequate voltage to the HCU module is required during the system bleed.
Connect the diagnostic tool.
2. Access the service bleed function. Access the service bleed function on the diagnostic tool and follow the directions.
