Mariner 2WD V6-3.0L VIN 1 (2006)
Removal and Installation
NOTE: Installation of a new suction accumulator is not required when repairing the air conditioning system, except when there is physical evidence of
contamination from a failed A/C compressor or damage to the suction accumulator.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Recover the refrigerant.
3. Remove the RH splash shield.
4. If equipped, disconnect the engine block heater electrical connector.
5. Disconnect the A/C compressor electrical connector.
6. Remove the compressor inlet fitting bolt and disconnect the fitting.
-
Discard the O-ring seal.
-
To install, tighten to 20 Nm (15 lb-ft).
7. Remove the 2 suction accumulator to compressor line bracket nuts.
-
To install, tighten to 8 Nm (71 lb-in).
8. Disconnect the suction accumulator outlet spring lock coupling.
-
Discard the O-ring seals.
9. Remove the suction accumulator-to-compressor line.
10. To install, reverse the removal procedure.
-
Install new O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
11. Evacuate, leak test, and charge the refrigerant system.
Compressor to Condenser Discharge Line
