Mariner 2WD V6-3.0L VIN 1 (2006)
Idle Speed/Throttle Actuator - Electronic: Service and Repair
IDLE AIR CONTROL (IAC) VALVE
Removal and Installation
1. Disconnect the battery ground cable.
2. Disconnect the idle air control (IAC) valve electrical connector.
3. Remove the 2 bolts and the IAC valve and discard the gasket.
-
To install, tighten to 10 Nm (89 lb-in).
-
Clean and inspect all sealing surfaces. Install new gasket.
4. To install, reverse the removal procedure.
