Mariner 2WD V6-3.0L VIN 1 (2006)
3. Remove the 7 retainers and the LH splash shield.
-
To install, tighten to 10 Nm (89 lb-in).
4. Disconnect the catalyst monitor sensor electrical connector and detach the wiring retainer(s).
5. NOTE: If necessary, lubricate the sensor threads with penetrating and lock lubricant to assist in removal.
Using the special tool, remove the catalyst monitor sensor.
-
To install, tighten to 48 Nm (35 lb-ft).
6. NOTE: Apply a light coat of anti-seize lubricant to the threads of the catalyst monitor sensor.
To install, reverse the removal procedure.
