Mariner 2WD V6-30L VIN 1 (2006) - Evaporative Emissions Hose Repair
Evaporative Emissions Hose: Service and Repair
FUEL VAPOR CONTROL TUBE ASSEMBLY VALVE
Removal and Installation
WARNING:
-
The evaporative emission system contains fuel vapor and condensed fuel vapor. Although not present in large quantities, it still presents
the danger of explosion or fire. Disconnect the battery ground cable from the battery to minimize the possibility of an electrical spark
occurring, which can cause a fire or explosion if fuel vapor or liquefied fuel are present in the area. Failure to follow these instructions
may result in personal injury.
-
Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related component. Highly flammable
mixtures are always present and may be ignited. Failure to follow these instructions may result in personal injury.
-
Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any
fuel-related components. Highly flammable mixtures are present and may be ignited. Failure to follow these instructions can result in
personal injuries.
1. Remove the fuel tank.
2. Release the fuel vapor tube quick connect coupling from the fuel vapor control tube assembly valve fitting.
3. Release the fuel vapor control assembly valve tube quick connect coupling from the evaporative emissions (EVAP) canister vent solenoid.
4. Disconnect the fuel vapor control tube assembly valve quick connect coupling from the fuel filter vapor tube.
5. Remove the fuel vapor control tube assembly valve.
6. To install, reverse the removal procedure.
-
Carry out a leak text. See: Testing and Inspection/Evaporative Emission System Leak Test
-
Carry out the evaporative emission repair verification drive cycle. See: Testing and Inspection/Evaporative Emission Repair Verification
Drive Cycle
