Mariner 2WD V6-3.0L VIN 1 (2006)
2. Disconnect the battery ground cable.
3. Remove the evaporative emission (EVAP) canister assembly.
4. Disconnect the fuel vapor hose from the EVAP canister vent solenoid.
5. Release the EVAP canister vent solenoid from the EVAP canister can.
-
Apply clean oil to the EVAP canister vent solenoid O-ring seal prior to installation.
6. To install, reverse the removal procedure.
-
Carry out the evaporative emission system leak test. See: Testing and Inspection/Evaporative Emission System Leak Test
-
Carry out the evaporative emission repair verification drive cycle. See: Testing and Inspection/Evaporative Emission Repair Verification
Drive Cycle
