Mariner 2WD V6-3.0L VIN 1 (2006)
procedure again.
1. Depower the system.
2. Remove the steering wheel access cover.
3. Disconnect the 2 electrical connectors to the clockspring.
4. Loosen the steering wheel mounting pinion shaft to release the steering wheel from the steering column shaft.
-
To install, tighten to 16 Nm (12 lb-ft).
5. Remove the steering wheel.
6. Remove the screws and the steering wheel front cover.
7. Remove the nuts and the steering wheel armature.
-
To install, tighten to 16 Nm (12 lb-ft).
8. Disconnect the steering wheel accessories and remove the driver air bag module.
1
Disconnect and slide the connector off the wire shield.
2
Route the wire harness out of the wire shield.
3
If equipped, remove the screws.
4
If equipped, separate the switches from the steering wheel.
5
Lift the driver air bag module out of the steering wheel.
9. To install, reverse the removal procedure.
10. Repower the system.
