Mariner 2WD V6-3.0L VIN 1 (2006)
2. NOTE: Mark the hood latch position prior to removal of the bolts.
Position the hood latch assembly aside.
1
Loosen the hood latch nut.
2
Remove the hood latch bolts.
3
Position the hood latch aside.
3. Detach the wiring harness pin-type retainers.
4. Remove the radiator support bracket bolt.
5. Remove the front impact severity sensor bolt.
6. Disconnect the electrical connector and remove the front impact severity sensor.
Installation
1. Connect the electrical connector to the front impact severity sensor.
2. NOTE: Make sure the radiator support and front impact severity sensor mating surfaces are clean and free of foreign material.
Align the locator tabs of the front impact severity sensor to the openings in the radiator support bracket.
3. WARNING: The tightening torque of the air bag front impact severity sensor retaining bolt is critical for correct system operation.
Install the front impact severity sensor bolt.
-
Tighten to 12 Nm (9 lb-ft).
4. Install the radiator support bracket bolt.
-
Tighten to 12 Nm (9 lb-ft).
5. Attach the wiring harness pin-type retainers.
