Mariner 2WD V6-3.0L VIN 1 (2006)
must be replaced if the safety belt assembly's "automatic locking retractor" feature or any other safety belt function is not operating properly when
inspected according to the functional inspection procedures. Failure to replace the belt and retractor assembly could increase the risk of injury in
collisions.
NOTE: RH rear safety belt retractor shown, LH side similar.
1. Remove the rear quarter trim panel.
2. Remove the rear safety belt retractor anchor bolt.
-
To install, tighten to 47 Nm (35 lb-ft).
3. Remove the bolt and the rear safety belt retractor.
-
To install, tighten to 47 Nm (35 lb-ft).
4. To install, reverse the removal procedure.
5. Check the active restraint system for correct operation.
-
Make sure that after the rear safety belt retractor is installed, the retractor is not in the automatic locking retractor (ALR) mode.
Rear Center Safety Belt Retractor
REAR CENTER SAFETY BELT RETRACTOR
