Mariner 2WD V6-3.0L VIN 1 (2006)
6. CAUTION: Use care when separating the seat upholstery from the hook-and-loop strip, or the hook-and-loop strip can be torn from the
seat cushion foam pad.
Detach the seat cushion trim cover J-clips from the seat cushion pan and remove the seat cushion trim cover.
7. Remove the seat cushion foam pad.
8. Bend the retaining tab away from the pressure sensor, then slide the pressure sensor off the bracket.
9. CAUTION: Care must be taken to prevent damage to the set cushion pan when removing the rivets.
Remove the 2 rivets and the OCS ECU.
10. Remove the 2 pin-type retainers from the OCS bladder and seat cushion pan.
11. Feed the OCS hose and pressure sensor through the seat cushion pan opening and remove as an assembly with the bladder.
Installation
NOTE: If installing an OCS service kit, refer to Occupant Classification Sensor- Service Kit. See: Occupant Classification Sensor - Service Kit
1. Bend the retaining tab back on the pressure sensor component bracket.
2. CAUTION:
-
Inspect the occupant classification sensor bladder, seat cushion pan and support assembly for any foreign objects, before installing the
occupant classification sensor to the seat cushion pan. If any foreign objects are found, remove them. Failure to do so may result in
personal injury, in the event of an air bag deployment.
-
Failure to route the seat occupant classification sensor components through the correct seat cushion support opening can cause
