Mariner 2WD V6-3.0L VIN 1 (2006)
component failure.
-
While positioning the seat cushion pan and occupant classification sensor assembly, be careful not to damage any of the components. Failure
to do so can result in component failure.
Feed the OCS components (pressure sensor and hose) through the seat cushion pan opening.
3. Align the OCS bladder to the seat cushion pan.
4. Install the 2 pin-type retainers to the OCS bladder and seat cushion pan.
5. NOTE: Make sure the pressure sensor hose is not kinked during installation.
Install the pressure sensor onto the seat cushion pan bracket, making sure the retaining tab is completely engaged.
-
When installed correctly, an audible click will be heard and the pressure sensor will not be able to be removed from its bracket without
disengaging the retaining tab.
6. Slide the OCS ECU into the seat cushion pan bracket and install the rivets.
-
The OCS ECU must be correctly positioned and securely fastened in place. Failure to do so can set a diagnostic trouble code (DTC) in the
restraints control module (RCM).
7. Position the foam pad to the seat cushion pan.
8. CAUTION: Inspect the seat cushion pad and seat cushion trim cover for any foreign objects, before installing the seat cushion trim cover
to the seat cushion pad. If any foreign objects are found, remove them. Failure to do so may result in personal injury, in the event of an
air bag deployment.
Install seat cushion trim cover to seat cushion foam pad and attach the J-clips.
9. CAUTION: While positioning the seat cushion pan and occupant classification sensor assembly, be careful not to damage any of the
components. Failure to do so can result in component failure.
Position the seat cushion and pan assembly to the seat track.
-
To aid in installation, recline the seat.
10. Install the 4 seat cushion bolts retaining the seat cushion to the seat track.
-
Tighten to 15 Nm (11 lb-ft).