Mariner 2WD V6-3.0L VIN 1 (2006)
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Vehicle equipped with (3.0L) engine, remove the EGR valve.
3. NOTE: 2.3L engine shown, (3.0L) engine similar.
Remove the rear transaxle insulator bracket.
1
Remove the rear transaxle insulator bracket bolt.
^
To install, tighten to 90 Nm (66 ft. lbs.).
2
Remove the 2 rear transaxle insulator bracket nuts.
^
To install, tighten to 90 Nm (66 ft. lbs.).
3
Remove the rear transaxle insulator-to-bracket through-bolt.
^
To install, tighten to 90 Nm (66 ft. lbs.).
