Mariner 2WD V6-3.0L VIN 1 (2006)
Removal
NOTE: If removing the wheel hub, the wheel bearing must be replaced.
1. Remove the wheel knuckle.
2. Using the special tool, press the wheel hub from the wheel bearing.
3. NOTE: This step may not be necessary if the inner wheel bearing race remains in the wheel knuckle after removing the wheel hub.
Using the special tool, press the inner wheel bearing race from the wheel hub.
4. Remove the snap ring.
5. Using the special tools, press the outer wheel bearing race from the wheel knuckle.
Installation
1. Position the wheel knuckle in a vise.
