Mariner 2WD V6-3.0L VIN 1 (2006)
6. Disconnect and remove the front cooler tube from the transaxle case.
^
To install, tighten to 25 Nm (18 ft. lbs.).
7. Disconnect and remove the rear cooler tube from the transaxle case.
^
To install, tighten to 25 Nm (18 ft. lbs.).
8. Disconnect and remove the fluid cooler tube bracket from the transaxle case.
^
To install, tighten to 25 Nm (18 ft. lbs.).
9. Fill the transaxle with clean automatic transmission fluid.
10. Remove the fluid cooler tubes from under the vehicle and install new as necessary.
11. To install, reverse the removal procedure.
