Mariner 2WD V6-3.0L VIN 1 (2006)
Transmission Speed Sensor: Service and Repair
Output Shaft Speed (OSS) Sensor
Output Shaft Speed (OSS) Sensor
Material
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 7 retainers and the LH splash shield.
^
To install, tighten to 10 Nm (89 inch lbs.).
3. Remove the output shaft speed (OSS) sensor
1
Disconnect the OSS electrical connector.
2
Remove the OSS sensor bolt.
3
Remove the OSS sensor.
^
To install, tighten to 12 Nm (9 ft. lbs.).