Mariner 2WD V6-3.0L VIN 1 (2006)
4. Remove the drain plug and drain the fluid.
5. Remove the LH halfshaft.
6. Using the special tools, remove and discard the LH differential seal.
Installation
1. Using the special tool, install the LH differential seal.
2. Install the LH halfshaft.
3. Using a small amount of pipe sealant on threads, install the transaxle drain plug.
^
Tighten to 40 Nm (30 ft. lbs.).
4. Remove the fill plug on the side of the transaxle.
5. Fill the transaxle with clean automatic transmission fluid as specified until the level reaches the bottom of the fill plug hole.
