Mariner 4WD L4-2.3L VIN Z (2005)
18. Position the seat position sensor interrupt bracket, then install the two bolts.
19. Position the electrical connector bracket and install the two bolts.
20. Position the seat track in the vehicle.
-
The left and right front mounting feet holes should align with the floor pan mounting holes, without pushing or pulling the seat track to force
alignment. Check the witness marks (indentations) in the carpet. The tracks should line up closely with them.
-
If the seat track does not align to the vehicle, check to make sure the index marks on the inboard and outboard track rails and guides are still in
alignment. Repeat the necessary steps until the index marks align.
21. Install the seat track.
22. Install the seat and repower the SRS.
