Mariner 4WD L4-2.3L VIN Z (2005)
Refer to the appropriate Component or System to determine the location of the front air bag sensors.
The side impact sensors are located at or near the base of the B-pillar.
To deplete the backup power supply energy, disconnect the negative battery cable and wait at least one minute. Make sure to disconnect auxiliary
batteries and power supplies (if equipped). Failure to follow these instructions may result in personal injury.
NOTE:
-
The passenger seat is equipped with an occupant classification sensor (OCS) system and is replaced as an assembly.
-
The power seat and manual seat are similar.
1. WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions and notes in the supplemental restraint
system (SRS) depower/repower procedure. Failure to follow these instructions may result in personal injury.
Remove the front seat and depower the supplemental restraint system (SRS).
2. Remove the 4 front seat track bolts.
-
To install, tighten to 23 Nm (17 lb-ft).
3. If equipped, disconnect the front seat cushion heated seat grid electrical connector.
4. Remove the front seat cushion cover from the front seat cushion pan.
5. To install, reverse the removal procedure.
6. Install the front seat and repower the supplemental restraint system (SRS).
