Mariner 4WD L4-2.3L VIN Z (2005)
The side impact sensors are located at or near the base of the B-pillar.
To deplete the backup power supply energy, disconnect the negative battery cable and wait at least one minute. Be sure to disconnect auxiliary
batteries and power supplies (if equipped). Failure to follow these instructions may result in personal injury.
NOTE:
-
The driver seat and passenger seat are similar.
-
The power seat and manual seat are similar.
1. WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions and notes in the supplemental restraint
system (SRS) depower/repower procedure. Failure to follow these instructions may result in personal injury.
Remove the front seat and depower the SRS.
2. Using a small flat-blade screwdriver, release the locking tab and slide the heated seat module off the bracket.
-
Disconnect the electrical connector.
3. To install, reverse the removal procedure.
4. Install the front seat and repower the SRS.
