Mariner 4WD L4-2.3L VIN Z (2005)
Vacuum/Pressure Pump: Service and Repair
LUMBAR ASSEMBLY
Removal and Installation
WARNING:
-
Never probe the connectors on the air bag module or pretensioner. Doing so may result in pretensioner or air bag deployment and may
result in personal injury. Failure to follow these instructions may result in personal injury.
-
The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when
handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so
may result in pretensioner or air bag deployment. Failure to follow these instructions may result in personal injury.
-
To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing
any front air bag or side air curtain supplemental restraint system (SRS) components and before repairing, replacing, adjusting or
striking components near the front air bag or side air curtain sensors, such as doors, instrument panel, console, door latches, strikers,
seats and hood latches.
Refer to the appropriate Component or System to determine the location of the front air bag sensors.
The side impact sensors are located at or near the base of the B-pillar.
To deplete the backup power supply energy, disconnect the negative battery cable and wait at least one minute. Be sure to disconnect
auxiliary batteries and power supplies (if equipped). Failure to follow these instructions may result in personal injury.
NOTE: The power seat and manual seat are similar.
1. WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions and notes in the SRS depower/repower
procedure. Failure to follow these instructions may result in personal injury.
Remove the front seat backrest cover and depower the SRS.
2. Remove the front seat backrest cushion.
3. Remove the 2 manual lumbar control screws and the manual lumbar assembly.
-
To install, tighten to 3 Nm (27 lb-in).
4. To install, reverse the removal procedure.
