Mariner 4WD L4-2.3L VIN Z (2005)
3. Disconnect the electrical connector by rotating the protective cover.
4. Remove the brake line-to-HCU fittings.
^
To install, tighten to 15 Nm (11 ft. lbs.).
5. Remove the 3 HCU bracket-to-frame bolts.
^
To install, tighten to 23 Nm (17 ft. lbs.).
6. Remove the 3 ABS module screws.
^
To install, tighten to 2 Nm (18 inch lbs.).
7. Remove the ABS module.
8. Remove the 3 bracket-to-HCU bolts.
^
To install, tighten to 9 Nm (80 inch lbs.).
9. Remove the HCU.
10. To install, reverse the removal procedure.
^
Bleed the brake system.
