Mariner 4WD L4-2.3L VIN Z (2005)
Parking Brake Control: Service and Repair
Parking Brake Control
Removal and Installation
1. Remove the floor console.
2. Remove the parking brake control boot.
^
Pull the parking brake control boot up and over the lever.
3. Release the parking brake control.
4. Remove the front cable adjusting nut.
5. Remove the 4 parking brake control bolts.
^
To install, tighten to 24 Nm (18 ft. lbs.).
6. Disconnect the warning indicator switch electrical connector.
7. Remove the parking brake control.
^
Disconnect the front parking brake cable.
8. To install, reverse the removal procedure.
^
Adjust the parking brake cable.
