Mariner 4WD L4-2.3L VIN Z (2005)
Oil Pressure Sender: Service and Repair
Oil Pressure Sender
Material
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 5 bolts and the RH splash shield.
^
To install, tighten to 9 Nm (80 inch lbs.).
3. Disconnect the oil pressure sender electrical connector.
4. Remove the oil pressure sender.
^
To install, tighten to 15 Nm (11 ft. lbs.).
5. To install, reverse the removal procedure.
^
Apply pipe sealant with Teflon to the oil pressure sender threads.
