Mariner 4WD L4-2.3L VIN Z (2005)
The warning messages can interrupt the display until cleared or reset by the driver. The warning messages are either single cycle, non-resettable, or
repetitive warning messages.
The single cycle warning messages display once whenever the ignition switch is turned to the ON position or a fault occurs in a system, and can be
cleared by pressing the RESET button. The single cycle warning messages are:
-
liftgate ajar
-
liftgate glass ajar
-
service emission system
-
low brake fluid
-
service brake system
-
check left headlamp
-
check right headlamp
-
check left turn lamps
-
check right turn lamps
-
check left high beam
-
check right high beam
-
check brake lamps
-
check parking lamps
-
washer fluid low
-
check fuel cap
-
change oil soon
-
change oil now
-
low fuel
-
service 4x4
-
turn signal on
The repetitive warning message (park brake ON) displays whenever the ignition switch is turned to the ON position or a fault occurs in a system.
The repetitive warning message appears again after a 10-minute interval until the condition is corrected.
The non-resettable warning messages display whenever the ignition switch is turned to the ON position and a fault occurs in a system. The fault
must be corrected to clear the non-resettable warning messages.
The non-resettable warning messages are:
-
high engine temperature
-
driver door ajar
-
passenger door ajar
-
driver rear door ajar
-
passenger rear door ajar
Temporary Alert Messages
The temporary alert display interrupts the current display to show the status of an event that has just happened. The temporary alert messages are:
-
4x4 locked temporarily
-
4x4 disabled temporarily
-
4x4 auto restored
PRINCIPLES OF OPERATION - ESCAPE HYBRID
The message center electronic functions use both hardwired and CAN circuits to receive information. It is very important to understand:
-
where the input (command) originates.
-
all the information (messages) necessary in order for a feature to operate.
-
which module(s) receive(s) the input or command message.
-
which module controls the output of the feature.
Display Information
The display modes are:
-
information
-
setup
-
system check
-
warning
-
temporary alert
Various message center information can be selected and reset by pressing the following buttons:
-
SET
-
INFO
The select display and the reset display time-out and default to the information display mode. The temporary alert display interrupts the current display
