Mariner 4WD L4-2.3L VIN Z (2005)
2. Disconnect the battery ground cable.
3. Disconnect the evaporative emission (EVAP) canister vent solenoid electrical connector.
4. Disconnect the fuel vapor hose from the dust separator.
5. Squeeze the coupling opposite of the release tabs and pull to release the fuel vapor tube quick connect coupling from the EVAP canister.
6. Remove the 2 nuts, 3 bolts and the EVAP canister assembly.
-
To install, tighten to 7 Nm (62 lb-in).
7. To install, reverse the removal procedure.
8. Carry out the evaporative emission system leak test. See: Testing and Inspection/Evaporative Emission System Leak Test
9. Carry out the evaporative emission repair verification drive cycle. See: Testing and Inspection/Evaporative Emission Repair Verification Drive
Cycle
