Mariner 4WD L4-2.3L VIN Z (2005)
1. Position the fuel tank filler pipe assembly in the vehicle.
-
Install the fuel filler pipe hose and clamp onto the fuel tank.
-
Tighten to 4 Nm (36 lb-in).
2. Connect the fuel vapor vent hose to the evaporative emissions canister.
3. Attach the fuel vapor vent hose retainer clips.
4. CAUTION: Make sure the vapor tube clicks into place when installing the tube. To make sure the tube is fully seated, pull on the tube.
NOTE: Apply clean engine oil to the end of the tube before inserting the tube into the connector.
Connect the fuel vapor control tube assembly valve quick connect coupling onto the fuel tank filler tube.
-
Pull on the coupling to make sure it is fully engaged.
5. Install the fuel filler pipe mounting screw.
-
Tighten to 10 Nm (89 lb-in).
6. Using the special tool, install the fuel tank tube shield with new rivets.
7. Install the 2 fuel filler pipe mounting screws.
-
Tighten to 5 Nm (42 lb-in).
8. Turn the ignition key to the ON position to pressurize the fuel system.
9. Visually inspect the fuel system for leaks.
