Mariner 4WD L4-2.3L VIN Z (2005)
2. NOTE: If equipped with a moonroof and/or rear window wiper assembly, make sure of correct moonroof drain hose and/or rear window solvent
hose routing.
Install the safety canopy rear hook.
3. Hook the safety canopy module to the C-pillar.
4. Install the 2 safety canopy module bolts located near the top of the A and B-pillars.
-
Tighten to 8 Nm (71 lb-in).
5. If installing the same safety canopy module, join the tether to the pin-type retainer. If a new safety canopy module is being installed, attach the
tether with the pin-type retainer.
6. NOTE: If equipped with a moonroof and/or rear window wiper assembly, do not pinch the front moonroof drain hose and/or rear window washer
solvent hose.
Install the A-pillar tether bolt.
-
Tighten to 8 Nm (71 lb-in).
7. Install the 2 safety canopy module bolts near the top of the C-pillar and between the B and C-pillars.
-
Tighten to 8 Nm (71 lb-in).
8. Install the 2 bolts to the safety canopy module tether at the B-pillar.
-
Tighten to 8 Nm (71 lb-in).
9. If the vehicle is equipped with a rear window wiper assembly, position the hose and attach the hose clips.
