mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

SRS - Passenger Air Bag Lamp ON/DTC C1414 Set|Page 5892 > < Front Impact Severity Sensor|Page 5883
Page 1
background image

Seat Occupant Sensor: All Technical Service Bulletins
SRS - Passenger Air Bag Lamp ON/DTC C1414 Set

TSB 05-15-14

08/08/05

PASSENGER AIR BAG DISABLED (PAD) LAMP
INTERMITTENTLY ON WHILE DRIVING - DTC C1414
RETRIEVED DURING OCS DIAGNOSIS/REPAIR

FORD:
2005 Escape Hybrid, Escape

MERCURY:
2005 Mariner

ISSUE
Some 2005 Escape/Escape Hybrid and Mariner vehicles may exhibit the passenger air bag disabled (PAD) lamp intermittently on while driving with the
passenger seat occupied, or diagnostic trouble code (DTC) C1414.

ACTION
Revised occupant classification system (OCS) Service Kits are available for vehicles built at Kansas City Assembly Plant from Job 1 to 2/2/2005, and for
vehicles built at Ohio Assembly Plant from Job 1 to 2/8/2005. Install a revised OCS Service Kit to correct the intermittent PAD lamp. It is necessary to
re-zero the OCS system after components are replaced. Refer to Workshop Manual Section 501-20B for this procedure.

For DTC C1414, ensure the correct components are installed. Refer to the Service Procedure for descriptions of PAD lamp operation and DTC C1414
origination. Refer to the TSB charts for Service Kit selection and/or correct component verification.

SERVICE PROCEDURE

NOTE

THE 11TH DIGIT OF THE VIN CAN BE USED TO IDENTIFY THE ASSEMBLY PLANT (KANSAS CITY = K, OHIO = D).

NOTE

SRS - Passenger Air Bag Lamp ON/DTC C1414 Set|Page 5892 > < Front Impact Severity Sensor|Page 5883