Mariner 4WD L4-2.3L VIN Z (2005)
when inspected according to the functional inspection procedures. Failure to replace the belt and retractor assembly could increase the risk of injury in
collisions.
NOTE: The RH rear safety belt retractor is shown, LH side similar.
1. Remove the rear quarter trim panel.
2. Remove the rear safety belt retractor anchor bolt.
-
To install, tighten to 47 Nm (35 lb-ft).
3. Remove the bolt and the rear safety belt retractor.
-
To install, tighten to 47 Nm (35 lb-ft).
4. To install, reverse the removal procedure.
5. Check the active restraint system for correct operation.
-
Make sure that after the rear safety belt retractor is installed, the retractor is not in the automatic locking retractor (ALR) mode.
