Mariner 4WD L4-2.3L VIN Z (2005)
10. Unzip the 2 backrest trim cover zippers (one each side).
11. NOTE:
-
The inboard and outboard head restraint sleeves are not interchangeable.
-
The head restraint sleeves incorporate an alignment tab that must be aligned correctly when installed.
Squeeze together the tip of each head restraint sleeve and pull the 4 sleeves out of the frame tube.
12. CAUTION: Use care when separating the seat upholstery from the hook and loop strip, or the hook and loop strip can be torn from the
seat backrest foam pad.
Separate the hook and loop fasteners and remove the seat backrest trim cover.
13. Remove the backrest foam pad from the backrest frame.
14. Release the seat latch cable from the retractor.
15. Remove the 2 nuts and the safety belt guide.
-
To install, tighten to 40 Nm (30 lb-ft).
16. Remove the nut and the rear center safety belt retractor.
-
To install, tighten to 40 Nm (30 lb-ft).
17. To install, reverse the removal procedure.
18. Check the active restraint system for correct operation.
-
Make sure that after the rear safety belt retractor is installed, the retractor is not in the automatic locking retractor (ALR) mode.
