Mariner 4WD L4-2.3L VIN Z (2005)
Seat Sensor/Switch: Service and Repair
SEAT POSITION SENSOR
Removal and Installation
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
-
The seat must be in rearward position.
1. Depower the system.
2. Disconnect the seat position sensor electrical connector.
3. Remove the screw and the seat position sensor.
4. To install, reverse the removal procedure.
5. Repower the system.