Mariner 4WD L4-2.3L VIN Z (2005)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor - Rear
Wheel Speed Sensor - Rear
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Using a suitable tool, remove the grommet.
3. Disconnect the rear wheel speed sensor wire connector.
4. Remove the rear wheel speed sensor wire from the retainer.
5. Remove the 3 rear wheel speed sensor wire bolts.
^
To install, tighten to 9 Nm (80 inch lbs.).
6. NOTE: Clean off any debris that may have collected around the sensor before removal.
Remove the rear wheel speed sensor bolt from the wheel knuckle.
^
To install, tighten to 9 Nm (80 inch lbs.).
7. Remove the rear wheel speed sensor.
8. NOTE: Thoroughly clean the mounting surface.
To install, reverse the removal procedure.