Mariner 4WD L4-2.3L VIN Z (2005)
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.
1. Depower the system.
2. Remove the passenger seat.
3. Disconnect the electrical connector(s) and wiring clips.
1
Disconnect the seat wire harness OCS electrical connector from the service part OCS electrical connector.
2
Release the 2 wiring clips on the wiring harness from the cushion pan.
3
If equipped with heated seats, disconnect the heated seat module electrical connector, release the wiring clip on the wiring harness from the
cushion pan, and disconnect the 2 cushion element electrical connectors.
4. Remove the 4 seat cushion bolts retaining the seat cushion to the seat track.
5. CAUTION: While positioning the seat cushion pan and occupant classification sensor assembly, be careful not to damage any of the
components. Failure to do so can result in component failure.
Remove the seat cushion and pan assembly.
-
To aid in removal, recline the seat.
6. CAUTION: Use care when separating the seat upholstery from the hook-and-loop strip, or the hook-and-loop strip can be torn from the
seat cushion foam pad.
Detach the seat cushion trim cover J-clips from the seat cushion pan and remove the seat cushion trim cover.
