Mariner 4WD L4-2.3L VIN Z (2005)
Transmission Speed Sensor: Service and Repair
Turbine Shaft Speed (TSS) Sensor
Turbine Shaft Speed (TSS) Sensor
Material
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 7 retainers and the LH splash shield.
^
To install, tighten to 10 Nm (89 inch lbs.).
3. Remove the turbine shaft speed (TSS) sensor.
1. Disconnect the TSS electrical connector.
2. Remove the TSS sensor bolt.
3. Remove the TSS sensor.
^
To install, tighten to 13 Nm (10 ft. lbs.).
4. NOTE: When installing the sensor, lubricate the O-ring seal with clean transmission fluid.