Mariner 4WD L4-2.3L VIN Z (2005)
Using the special tool, separate the tie-rod from the wheel knuckle.
6. Remove the lower ball joint pinch bolt nut and the pinch bolt.
7. Remove the anti-lock brake system (ABS) wheel speed sensor bolt and position the sensor aside.
8. Separate the lower ball joint from the wheel knuckle.
9. Remove the 2 strut-to-knuckle nuts, bolts and the wheel knuckle.
Installation
1. Position the wheel knuckle and install the 2 strut-to-knuckle bolts and nuts.
^
Tighten to 115 Nm (85 ft. lbs.).
2. Position and align the ball joint stud into the wheel knuckle.
3. Install the lower ball joint pinch bolt and nut.
^
Tighten to 70 Nm (52 ft. lbs.).
4. Install the ABS wheel speed sensor and the bolt.
^
Tighten to 9 Nm (80 inch lbs.).
5. Position the tie rod-end into the wheel knuckle and install the tie-rod end-to-knuckle nut and a new cotter pin.
^
Tighten to 55 Nm (41 ft. lbs.).
6. Using the special tool, insert the halfshaft into the wheel hub.
7. Install the wheel hub nut.
^
Tighten to 290 Nm (214 ft. lbs.).
8. Install the brake disc.
9. Check and, if necessary, align the front end.