Mariner 4WD L4-2.5L (2010)
doors, liftgate and liftgate glass are closed.
Close all the doors, the liftgate and the liftgate glass.
2. Confirm that the ignition is in the OFF position.
3. NOTE: Steps 3 through 7 must be carried out within 30 seconds.
Turn the ignition from OFF to ON.
4. Press the door lock control switch UNLOCK button 3 times.
5. Turn the ignition from ON to OFF.
6. Press the door lock control switch UNLOCK button 3 times.
7. Turn the ignition from OFF to ON. The horn will chirp once to indicate the system is in the enable/disable mode.
8. Press the door lock control switch LOCK button once, then the UNLOCK button once to toggle the auto-unlock feature ON/OFF. The horn will
chirp once to indicate auto-unlock is disabled. If the horn chirps twice (one short and one long chirp), the auto-unlock feature has been enabled.
9. Turn the ignition to the OFF position to exit the enable/disable mode. The horn will chirp once to indicate the procedure is complete.
Auto-Unlock Programming Using the Keyless Entry Keypad Procedure (If Equipped)
NOTE: The auto-unlock feature is not available on vehicles equipped with a manual transmission.
1. Turn the ignition to the OFF position.
2. Close all the doors, the liftgate and the liftgate glass.
3. Enter the 5-digit permanent entry code on the keyless entry keypad.
4. Within 5 seconds of entering the code, press and hold the 3/4 button on the keypad. While holding the 3/4 button, press and release the 7/8 button
twice.
5. Release the 3/4 button. The horn will chirp once to indicate auto-unlock is disabled. If the horn chirps twice (chirp followed by a honk), the
auto-unlock feature has been enabled.
Auto-Unlock Programming Using the Message Center Procedure (If Equipped)
NOTE: The auto-unlock feature is not available on vehicles equipped with a manual transmission.
1. To disable/enable the auto-unlock feature, select AUTOUNLOCK [ON] OFF from the SETUP control for the current display mode.
2. Press the RESET control to turn the auto-unlock ON or OFF.
