Mariner 4WD L4-2.5L (2010)
13. Install the cushion cover and attach the retainers to the seat cushion frame.
14. NOTICE: While positioning the seat cushion frame and Occupant Classification Sensor (OCS), be careful not to damage any of the
components. Failure to do so can result in component failure.
Position the seat cushion assembly to the seat track and install the 4 seat track-to-cushion frame bolts.
-
Tighten to 25 Nm (18 lb-ft).
15. NOTE: Do not tie strap any wiring to the OCS bladder and pressure sensor hose.
-
Connect the seat wire harness OCS system electrical connector to the service part OCS system electrical connector.
-
Install the 2 wiring clips on the wiring harness to the cushion frame.
-
Tie strap the unused seat wire harness pressure sensor electrical connector safely aside.
-
Tie strap all loose wire harnesses and electrical connectors safety aside.
All seats
16. If equipped, connect the heated seat components.
-
Install the heated seat relay to the bracket on the cushion frame.
-
Connect the heated seat relay electrical connector.
-
Connect the cushion heater mat electrical connector and attach to the cushion frame.
17. Attach the seat electrical connector and wiring harness to the seat track.
18. Connect the safety belt buckle pretensioner and buckle switch electrical connectors.
-
Route the wiring harness between the seat track and cushion frame.
-
Attach the wiring harness pin-type retainer.
19. Install the seat backrest. For additional information, refer to Seat Backrest - Front See: Seat Back/Service and Repair/Removal and
Replacement/Seat Backrest - Front.
20. Install the seat. Do not prove out the Supplemental Restraint System (SRS) at this time. For additional information, refer to Seat - Front See:
Service and Repair/Seat - Front.
21. WARNING: Make sure the front passenger seat repair is complete, the seat and all attached components (head restraint, seat side shield,
etc.) are correctly assembled, and the seat is correctly installed to the vehicle before carrying out the System Reset. Failure to follow these
instructions may result in incorrect operation of the occupant classification sensor (OCS) system and increases the risk of serious
personal injury or death in a crash.
WARNING: Install a new occupant classification sensor (OCS) system service kit as a complete assembly. Never install only part of the
kit components. Failure to follow this instruction may result in incorrect operation of the OCS system and increases the risk of serious
personal injury or death in a crash.
