Mariner 4WD L4-2.5L (2010)
NOTE: Refer to the appropriate Engine for the specification.
1. Using the Feeler Gauge Set, measure the connecting rod bend on a suitable alignment fixture. Follow the instructions of the fixture manufacturer.
Verify the bend measurement is within specification.
Connecting Rod Bushing Diameter
Connecting Rod Bushing Diameter
NOTE: Refer to the appropriate Engine for the specification.
1. Use a telescoping gauge to determine the ID of the connecting rod bushing, if equipped.
2. Measure the telescoping gauge with a micrometer. Verify the diameter is within specification.
Connecting Rod Cleaning
Connecting Rod Cleaning
NOTICE: Do not use a caustic cleaning solution or damage to connecting rods can occur.
1. NOTE: The connecting rod large end is a matched set. The connecting rod cap must be installed on the original connecting rod in the original
position. Do not reverse the cap. Parts are not interchangeable.
Mark and separate the parts and clean with solvent. Clean the oil passages.
