Mariner 4WD L4-2.5L (2010)
7. Loosen the 2 LH bellhousing-to-engine bolts 5 mm (0.19 in).
Front Wheel Drive (FWD) vehicles
8. Loosen the 1 (manual transaxle) or 2 (automatic transaxle) RH engine-to-bellhousing bolt 5 mm (0.19 in).
All vehicles
9. Remove the 2 oil pan-to-bellhousing bolts.
10. Remove the 2 bellhousing-to-oil pan bolts.
11. Slide the transaxle rearward 5 mm (0.19 in).
12. Drain the engine oil.
-
Install the drain plug.
-
Tighten to 28 Nm (21 lb-ft).
13. Remove the 4 engine front cover-to-oil pan bolts.
14. Remove the 13 bolts and the oil pan.
Installation
All vehicles
1. NOTICE: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools
cause scratches and gouges, which make leak paths. Use a plastic scraping tool to remove traces of sealant.
Clean and inspect all mating surfaces.
2. NOTE: If the oil pan is not secured within 10 minutes of sealant application, the sealant must be removed and the sealing area cleaned with metal
surface prep. Allow to dry until there is no sign of wetness, or 10 minutes, whichever is longer. Failure to follow this procedure can cause future
oil leakage.
Apply a 2.5 mm (0.09 in) bead of silicone gasket and sealant to the oil pan-to-engine block and to the oil pan-to-engine front cover mating surface.
3. Position the oil pan onto the engine and install the oil pan bolts finger-tight.
