Mariner 4WD L4-2.5L (2010)
2. Install the CKP sensor and the 2 bolts.
-
Do not tighten the bolts at this time.
3. Adjust the CKP sensor with the Crankshaft Sensor Aligner.
-
Tighten the 2 bolts to 7 Nm (62 lb-in).
4. Connect the CKP sensor electrical connector.
5. Remove the 6 mm x 18 mm bolt from the crankshaft pulley.
6. Install the engine plug bolt.
-
Tighten to 20 Nm (177 lb-in).
7. Install the RH splash shield, 5 bolts and the pin-type retainer (not shown).
-
Tighten to 9 Nm (80 lb-in).
8. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.
