Mariner 4WD L4-2.5L (2010)
GO to T26.
-------------------------------------------------
T26 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE RCM DISCONNECTED
-
Disconnect: RCM C2041b .
-
Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.
-
Are the resistances greater than 1,000 ohms?
Yes
CONNECT the negative battery cable. GO to T38.
No
GO to T27.
-------------------------------------------------
T27 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE OCSM DISCONNECTED
-
Disconnect: OCSM C3285 .
-
Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.
-
Are the resistances greater than 1,000 ohms?
Yes
CONNECT the negative battery cable. GO to T39.
No
If the vehicle is equipped with an Accessory Protocol Interface Module (APIM), GO to T28.
If the vehicle is not equipped with an APIM, GO to T29.
-------------------------------------------------
T28 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE APIM DISCONNECTED
-
Disconnect: APIM C3338 .
-
Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and ground; and between the DLC C251-14, circuit
VDB05 (WH), harness side and ground.
-
Are the resistances greater than 1,000 ohms?
