Mariner 4WD L4-2.5L (2010)
INSTALL the removed fuse. GO to U13.
-------------------------------------------------
U10 VERIFY VEHICLE EQUIPMENT - FCIM
-
Inspect the vehicle for an FCIM.
-
Is the vehicle equipped with an FCIM?
Yes
GO to U11.
No
GO to U12.
-------------------------------------------------
U11 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE FCIM DISCONNECTED
NOTE: When re-running the network test, the network test application must be first closed or the screen display reverts back to the prior run network
test results.
-
Disconnect: FCIM C2402 .
-
Enter the following diagnostic mode on the scan tool: Network Test .
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
CONNECT the FCIM. GO to Pinpoint Test O. See: Pinpoint Test O: The Front Controls Interface Module (FCIM) Does Not Respond To The Scan
Tool
No
CONNECT the FCIM. GO to U12.
-------------------------------------------------
U12 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE GPSM DISCONNECTED
NOTE: When re-running the network test, the network test application must be first closed or the screen display reverts back to the prior run network
test results.
-
Disconnect: GPSM C2300 .
-
Enter the following diagnostic mode on the scan tool: Network Test .
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
CONNECT the GPSM. GO to Pinpoint Test M. See: Pinpoint Test M: The Global Positioning System Module (GPSM) Does Not Respond To The
Scan Tool
No
CONNECT the GPSM. GO to Pinpoint Test N. See: Pinpoint Test N: The Front Display Interface Module (FDIM) Does Not Respond To The Scan
Tool
-------------------------------------------------
U13 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE IC DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display reverts back to the prior run network
test results.
-
Disconnect: SJB Fuses 26 (10A), 29 (5A) and 43 (10A) .
-
Enter the following diagnostic mode on the scan tool: Network Test .