Mariner 4WD L4-25L (2010): Evaporative Emission Control Canister TSB (Page 3168)
3. Disconnect the Evaporative Emission (EVAP) canister electrical connector.
4. Disconnect the fresh air tube from the EVAP canister.
5. Disconnect the fuel vapor tube assembly-to-EVAP canister fuel vapor tube quick connect coupling. For additional information, refer to Fuel
Delivery and Air Induction.
6. Disconnect the EVAP canister purge tube-to-fuel vapor tube quick connect coupling. For additional information, refer to Fuel Delivery and Air
Induction.
7. Remove the 2 nuts, 2 bolts and the EVAP canister assembly.
-
To install, tighten to 7 Nm (62 lb-in).
8. To install, reverse the removal procedure.
-
Carry out the Evaporative Emission System Leak Test. For additional information, refer to Evaporative Emission System Leak Test See:
Testing and Inspection.