Mariner 4WD L4-2.5L (2010)
19. Remove the bolt and the TR sensor detent spring.
20. Using a small pair of Vise Grips(R) or an equivalent suitable tool, remove and discard the TR sensor locking pin.
21. Remove the TR sensor in the following sequence.
1. Hold the TR sensor in place and slide the manual shaft outward until the manual shaft is out of the transaxle case.
2. Remove the TR sensor from the transaxle, leaving the park pawl actuating rod attached to the TR sensor.
Installation
All vehicles
1. NOTE: The TR sensor is easier to install into the transaxle from under the vehicle.
Install the TR sensor.
1. Install the TR sensor and park pawl actuating rod in the transaxle case.
2. Install the manual shaft in the transaxle case through the TR sensor.
