Mariner 4WD L4-2.5L (2010)
NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
1. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Air Bag(s)
Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering.
2. Remove the headliner.
3. Detach the A-pillar tether pin-type retainer from the A-pillar.
4. Remove the A-pillar tether bolt.
-
If the vehicle is equipped with a roof opening panel and/or rear window wiper assembly, note the roof opening panel drain hose and/or rear
window washer solvent hose position and routing for installation purposes.
5. Remove the 2 Safety Canopy(R) module bolts located near the top of the A- and B-pillars.
6. Disconnect the Safety Canopy(R) module electrical connector and detach the connector from the D-pillar.
7. Detach the Safety Canopy(R) module wiring clip from the roof panel brace.
8. Remove the 2 Safety Canopy(R) module bolts near the inflator (between the C- and D-pillars).
9. If equipped with a roof opening panel, disconnect the drain hose.
10. If equipped with a rear window wiper assembly, detach the hose clip and position the hose aside.
11. Remove the remaining 2 Safety Canopy(R) module bolts (1 near the top of the C-pillar and 1 between the B- and C-pillars).
12. Lift to unhook the Safety Canopy(R) module from the C-pillar.
