Mariner 4WD L4-2.5L (2010)
19. Remove the bolt and the TR sensor detent spring.
20. Using a small pair of Vise Grips(R) or an equivalent suitable tool, remove and discard the TR sensor locking pin.
21. Remove the TR sensor.
1. Hold the TR sensor in place and slide the manual shaft outward until the manual shaft is out of the transaxle case.
2. Remove the TR sensor from the transaxle, leaving the park pawl actuating rod attached to the TR sensor.
22. Using a suitable tool, remove the manual control lever shaft seal.
Installation
All vehicles
1. Using the Manual Lever Seal Installer, install a new manual control lever shaft seal.
2. NOTE: The TR sensor is easier to install into the transaxle from under the vehicle.
Install the TR sensor.
