Mariner 4WD L4-2.5L (2010)
10. Disconnect the Output Shaft Speed (OSS) sensor electrical connector.
11. Remove the main control cover grommet.
12. NOTICE: Be careful not to bend or twist the leadframe or the solenoid terminals when removing the leadframe or damage can occur to
the leadframe or the solenoids.
Remove the 5 screws and the leadframe from the solenoids by lifting it straight up evenly.
Installation
1. Install the Valve Body Alignment Pins in the solenoid body to align the lead frame for installation.
2. Position the leadframe on the Valve Body Alignment Pins and carefully install the leadframe by pushing straight down into the solenoids.
