Mariner 4WD L4-2.5L (2010)
NOTICE: If the rotational torque is less than specification, tighten the drive pinion nut in small increments until it is within specification.
Do not tighten the drive pinion nut more than 3 Nm (27 lb-in) or the collapsible spacer will be damaged. If the rotation torque is higher
than specification, the collapsible spacer has been compressed too far and a new collapsible spacer must be installed.
Using the Drive Pinion Flange Holding Fixture, install a new pinion nut.
3. Install the driveshaft. For additional information, refer to Drive/Propeller Shafts, Bearings and Joints.
